Filter
Top Products
Getting Started (Initial Setup)
22
If the displayed time drifts from the current time by more than one hour, select your
correct time zone and set the DST (See page 24).
When the VCR is hooked up via a cable box:
Before you begin:
Set up your cable box (See page 47).
1. Press GUIDE, then press 6 to bring up the CLOCK SET screen.
2. Check that item 1 is specified "CLOCK SET: AUTO".
If "CLOCK SET: MANUAL" is displayed, press 1 to switch it to "CLOCK SET: AUTO".
3. Press 2. The following screen appears to show that the clock is being set.
Since the VCR is searching for a broadcast station that transmits a time signal, the
channel indication on the cable box changes automatically.
4. The screen shown in step 3 above changes to a TV picture and the time appears in
the VCR's display.
It may take about five minutes for auto clock setting.
If the clock is not set after about five minutes have elapsed, press GUIDE then set the
clock manually (See page 25).
If the displayed time drifts from the current time by more than one hour, select your
correct time zone and set the DST (See page 24).
What to do if the displayed time drifts from the current time by more than one
hour
1. Press GUIDE, then press 6 to bring up the CLOCK SET screen. Check that item 1 is
specified "CLOCK SET: AUTO". Press 3 to bring up the TIME ZONE SETTING screen.