Filter
Top Products
Setup
______________________________________________________________________________________________
48
Client Configuration
Configure general remote access.
Remote Port – Use this port number when configuring remote access
software. The default port is 2000 but can be changed.
Web Port – Used for remote connections using a web browser. This port
should be open on the router. Default web port is 80.
Remote Config – Enable to allow an administrator to change configurations
using remote access software.
Max Transfer Speed – Set network bandwidth. If the network is low speed, set
this value as the network (aka. Bandwidth Throttling).
2000
80
ENABLE
100 Mbps
REMOTE PORT
WEB PORT
REMOTE CONFIG
MAX TRANSFER SPEED