Filter
Top Products
Honeywell
37
Motion Detection
The detection menu is shown as below. See Figure 4-13.
Event type: From the drop-down list you can select the “Motion
Detection” type.
Channel: Select the video channel for the motion detection setting.
Record Channel: Select the channel to activate the recording function
once the alarm has sounded. Please make sure you have set the MD
recording in the schedule interface (Main MenuSettingSchedule)
and automatic recording in manual record interface (Main Menu-
>Advanced->Manual Record)
Delay: When detected motion is completed, the system will continue
alarm output and recording for a specified time respectively. The value
ranges from 10-300(Unit: second).
Region: Click Select, the interface is shown as in Figure 4-14. Here
you can
set the motion detection zone. There are 396(PAL)/330(NTSC)
small zones.
Sensitivity: The system supports 6 levels. The sixth level has the
highest sensitivity. The fifth or lower levels are recommended to avoid
setting a false alarm.
Show message: The system will send message to the local host screen
to alarm you if you have enabled this function.
Send email: The system can send out an email to alert you when the
alarm occurs.
PTZ activation: Here you can set PTZ movement (of any video
channels) such as going to a preset when motion is detected in the
current video channel. Click Select, and you can see an interface is
shown as in Figure 4-15.
Period:
Click Set to determine the period for the channel to be armed
for motion detection. See the interface shown as in Figure 4-16. Here
you can
set for business days and non-business days. In Figure 4-16,
click Set, and you will see
an interface as shown in Figure 4-17. Here
you can
set your own business day and non-business day.
Alarm output: After the motion detection has occurred, the system
enables the peripheral alarm devices.
Tour: Here you can enable the tour function when the alarm occurs. It
is a one-window tour. Please go to Display on page 74 for tour interval
setup.