Filter
Top Products
GB50
User’s Manual
9. Software Update
In order to maintain proper performance of the product, it is essential to have the most up-to-date
software. Visit the Humax website to check the latest news and newly released software versions.
- http://www.humaxdigital.com.
It is recommended that you periodically check for the availability of software update.
9.1 OTA (Over the Air)
OTA, an abbreviation of Over–the-Air, is a standard for the transmission of software through a broadcast
system. The manufacturers reserve the right to decide when and where an update is made available. The
new software version is then downloaded via cable. The software update via cable will only occur under
the following circumstances.
1. The equipment should have appropriate loader software.
Caution: Please note that if normal loader software is not equipped, the product may not be updated
or operate properly after software update.
2. The manufacturer transmits the software via cable. The new version of the software is generally
detected automatically, but in case it is not, you should perform automatic or manual update.
Caution:
• Please be careful to keep the power on and the power cord plugged in during software update. If the
power is o during software update, fatal damage may be caused to the product.
• Please be careful not to pull out the signal line (co-axial cable) during software update. Update may be
interrupted and the product may not operate.
Note:
• Other functions will not activate while software update takes place.
• It may take 5~10 minutes to update software.
• Scheduling operation cannot work during software update.
1. If new software is found when powering on
1. A message will be displayed to notify that new software is
found.
2. Select Yes and press the OK button to update the software.
3. Starts downloading new software. Please wait until the
update is completed.
4 When completing the software update, the equipment is
automatically powered o and on again.