Filter
Top Products
B23
B24
H
B25
I
B26
ON
OF
F
B27
B28
E1
Go to step
on page 17
to attach grille.
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Secure the motor by tightening the 2 screws.
Test the motor. If the motor does not run, check the plug
connection.
Turn on the power source.
Connect wiring from the motor to the wiring cover plate.
10
11
Existing Construction – accessible from above
EXISTING FAN
C11
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new
motor housing (9” x 9.75”).
NO EXISTING FAN
Use the motor housing as a template to mark position.
9”
9
.7
5”
Cut out an opening for the housing.
C12
D
Slide the mounting rails into brackets.
OR
5/8
1/2
5/8
1/2
C13
Position the correct depth mark at the bottom edge of the
joist based on the thickness of your sheetrock.
C14
D
Mark position of screws by using holes as a template.
41721-01 12/25/2004 41721-01 12/25/2004