Filter
Top Products
C27
I
C28
ON
OF
F
C29
Secure the motor by tightening the 2 screws.
Turn on the power source.
14
15
Test the motor. If the motor does not run, check the plug
connection.
C30
E1
Go to step
on page 17
to attach grille.
EXISTING FAN
D11
E
D12
Existing Construction – accessible only from below
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new motor
housing (9” x 9.75”).
Move the housing into position above the ceiling.
D13
2
1
D14
Pull wires through strain relief.
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
E
D15
Screw pre-loaded screws into joist or framing.
A
A
A
Green
Black White
Bare Copper
Ground
D16
B
D
D17
F
1
2
Connect wires as shown.
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
Tighten the wiring cover plate screw.
•
D18
G
1/8" Bit
B14
41721-01 12/25/2004 41721-01 12/25/2004