Filter
Top Products
Technical specifications
Laser wavelength 650nm
Video system NTSC
Frequency response 20Hz20KHz ±1dB
Signal/noise ratio ≥95dB
Audio distortion + noise ≤-80(1KHz)
Channel separation ≥85dB
Dynamic range ≥85dB
Output
Audio out (analog audio) Output level: 2V±10% Load impedance: 10kohms
Audio out (digital audio) Output level: 0.5Vp - p
Video out Output level: 1Vp - p±20%
Video load impedance 75 Ohm, imbalance, negative polarity
Power supply DC 9V 2A
Allowable motion temperature 5 – 35degrees Celsius
Power Consumption ≤20W Dimensions 190×142×29mm
Weight 1.18 Kg (2.6 lb)
This manual is only for your reference. Any change to the design and specifications will not
be advised.
This product incorporates copyright protection technology that is protected by method claims
of certain U.S. patents and other intellectual property rights owned by Best Buy Corporation
and other rights owners. Use of this copyright protection technology must be authorized by
Best Buy Corporation, and is intended for home and other limited viewing uses only unless
otherwise authorized by Best Buy Corporation. Reverse engineering or disassembly is
prohibited.
Using the battery pack
Attach the battery pack properly by following these directions. Make sure that the battery
pack is attached firmly to the player when using it. Otherwise, the battery may become
detached and cause person injury. Charge battery pack before using it.
Attaching the battery pack
First disconnect the AC adapter and the power cord from the player, and then attach the
battery pack.
1. Turn the player off.
2. Turn the player upside down.
3. Insert the battery pack’s catches into the player’s corresponding holes. Then, slide
the battery pack until it is attached firmly.
Note: Remove the battery pack from the player after being used.
Charging the battery pack
1. Turn the player off. The battery pack will charge only when the POWER to the player
is turned OFF.
2. Attach the battery pack to the player.
3. Connect the supplied AC adapter and the power cord to the player. Charging starts,
and the POWER/CHG indicator light is illuminated. When the charging is complete
the indicator light turns off.
- 36 -