Filter
Top Products
12
Insignia NS-13CTV TV/DVD Combo
www.insignia-products.com
This DVD player is designed an manufactured
according to the Region Management
Information that is recorded on the DVD. If the
region number described on the DVD does not
correspond to the Region number on this DVD
player, this DVD player will not play the disc.
The region number of this DVD player is .
Protecting discs
Handling discs
• Do not touch the disc’s playback side.
• Do not attach paper or tape to the disc.
Cleaning discs
• Fingerprints and dust on the disc can cause
picture and sound deterioration. Wipe the
disc from the center outwards with a soft
cloth. Always keep the disc clean.
• If you cannot wipe off the dust with a soft
cloth, wipe the disc lightly with a slightly
moistened soft cloth and finish with a dry
cloth.
• Do not use any type of solvent such as
thinner benzine, commercially available
cleaners, or antistatic spray for vinyl. These
products may damage the disc.
Storing discs
• Do not store discs in a place subject to direct
sunlight or near a heat source.
• Do not store discs in a place subject to
moisture and dust such as a bathroom or
near a humidifier.
• Store discs vertically in a case. Stacking or
placing objects on discs outside of their
cases may cause warping.
Maintaining your television
To prevent fire or shock hazard, disconnect your
television from AC power when cleaning. The
finish on your television may be cleaned with a
dust cloth and cared for as you do your other
furniture. Use caution when cleaning and wiping
plastic parts. Mild soap and a soft, damp cloth
may be used.
Troubleshooting
The most common types of television
interference are as follows:
1
Problem Solution
Snowy picture • VHF/UHF: This is
usually caused by a
weak signal. Adjust
the antenna or install
an antenna amplifier.
Double image or ghosts • VHF/UHF: This is
usually caused by
reflections from a tall
building. Adjust the
direction of the
antenna or raise it.
Radio wave interference • VHF/UHF: This is
usually caused by
nearby radio
transmitters or
shortwave receiving
equipment.
High temperature electrothermal
interference
•VHF/UHF: This is
usually caused by
high temperature
electrothermal
equipment in a
nearby business.
No picture or sound. • Make sure that your
television is turned
on.
• Make sure that your
television is plugged
in.
Poor or no picture • Make sure that the
color, brightness,
and sharpness
controls are correctly
adjusted.
• Check for local
interference.
• Make sure that the
antenna or CATV
connector is
connected correctly.
• The station or cable
provider may be
experiencing
problems. Try a
different channel.