Filter
Top Products
20
NS-24L240A13 Insignia 24" LCD TV
www.insigniaproducts.com
B. If you select Cable, a message asks if you have
a cable box.
• Select No if no cable box is connected.
Your TV scans for available channels. The
scan may take several minutes.
• Select Ye s if a cable box is connected. A
message asks how you connected the
cable box to your TV.
• Select AV, Component, or HDMI if you
connected a cable box to your TV using
one of these cables. Read the message,
then press ENTER to close the wizard.
• Select Coaxial if you connected a cable
box to your TV using a coaxial cable.
Read the message, then press ENTER to
start the channel scan (VHF channels
only).
C. If you select Satellite Box, a message asks
how you connected the satellite box to your
TV.
• Select AV, Component, or HDMI if you
connected a satellite box to your TV using
one of these cables. Read the message,
then press ENTER to close the wizard.
• Select Coaxial if you connected a satellite
box to your TV using a coaxial cable. Read
the message, then press ENTER to start the
channel scan (VHF channels only).
12 To watch TV, press INPUT, press
S or T to
highlight the video input source for your TV in
the INPUT SOURCE list, then press ENTER.
• If your TV is connected to an antenna, cable TV
(no box), or cable or satellite TV box using a
coaxial cable, select TV.
• If your TV is connected to a cable or satellite
box using an HDMI cable or HDMI cable with a
DVI adapter, select HDMI 1 or HDMI 2.
• If your TV is connected to a cable or satellite
box using a component video cable, select
Component.
• If your TV is connected to a cable or satellite
box using a composite video cable, select AV.
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV. The power
indicator turns blue.
3 Press (power) again to turn off your TV. Your
TV enters standby mode, and the power
indicator LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The INPUT
SOURCE list opens.
2 Press
S or T to select a video input source, then
press ENTER.
Do you have a Cable Box?
No
Yes
Move
OK
ENTER
MEN U
EXIT
Exit
Previous
Select
How did you connect the
AV, Component, or HDMI
Coaxial
Move
OK
ENTER
MEN U
EXIT
Exit
Previous
Select
cable box to the TV?
How did you connect the
AV, Component, or HDMI
Coaxial
Move
OK
ENTER
MEN U
EXIT
Exit
Previous
Select
satellite box to the TV?
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
Warning
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
Note
If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
TV
AV
HDMI 1
HDMI 2
USB
INPUT SOURCE
Component
VGA