Filter
Top Products
4
Insignia NS-LCD22-09 22" W LCDTV 720P
www.insignia-products.com
Outdoor antenna grounding
If an outside antenna or cable system is
connected to your TV, make sure that the
antenna or cable system is grounded to provide
some protection against voltage surges and
built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA No. 70,
provides information with respect to correct
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of the antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
Note to CATV system installer
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC that provides guidelines for correct
grounding and in particular, specifies that the
cable ground must be connected to the
grounding system of the building as close to the
point of cable entry as practical.
Non-active pixels
The LCD panel contains almost 3 million thin film
transistors, which provide exceptionally sharp
video quality. Occasionally, a few nonactive
pixels may appear on the screen as a fixed blue,
green, or red point. These non-active pixels do
not adversely affect the performance of your TV,
and are not considered defects.
Mobile telephone warning
To avoid interference with your TV picture and
sound, operating problems, or even damage,
keep your cordless or cellular telephones away
from the TV.
Features
Front
1 Electric service equipment
2 Power service grounding electrode
system
3 Ground clamps
4 Grounding conductors
5 Antenna discharge unit
6 Grounding clamp
7 Antenna lead-in wire
6
7
5
2
1
3
4
# Button Description
1 VOL+ Press to increase the volume. In Menu
mode, functions as the right arrow to
go to the next menu or increase a
setting.
2 VOL– Press to decrease the volume. In Menu
mode, functions as the left arrow to go
to a previous menu or decrease a
setting.
3
CH
Press to go to the next higher channel.
In Menu mode, functions as the up
arrow.
4
CH
Press to go to the next lower channel.
In Menu mode, functions as the down
arrow.
5 MENU Press to show the on-screen menu.
6 INPUT Press to open the input source menu,
then press the arrows to cycle through
the available input sources.
7 POWER Press to turn on your TV or put it into
Standby mode.
1
2
3
5
6
4
7