Filter
Top Products
7
Insignia NS-LTDVD19 19" LCD TV/DVD Combo
www.insignia-products.com
Connecting a computer
To connect a computer:
1 Make sure that your LCD TV/DVD combo
and computer are turned off.
2 Connect a VGA cable to the VGA port on the
back of the computer and to the VGA IN jack
on the back of your LCD TV/DVD combo.
Make sure that you tighten the screws on the
ends of the VGA cable.
3 Connect a computer audio cable to the left
and right audio output jacks on the computer
and to the PC AUDIO IN jack on the back of
your LCD TV/DVD combo.
4 Turn on the computer and your LCD TV/DVD
combo, then press INPUT to select VGA.
Using basic controls
Turning your LCD TV/DVD combo on and
off
To turn your LCD TV/DVD combo on and off:
1 Plug the power cord into a power outlet. The
LED on the front of your LCD TV/DVD combo
lights yellow.
2 Press POWER. The LED lights green.
Adjusting the volume
To adjust the volume:
• Press VOL+ or VOL– to increase or
decrease the volume. A number appears
on the screen to indicate the volume level.
• Press MUTE to mute the sound. Press
MUTE again to restore the sound.
Selecting the video mode
To select the video mode:
• Press INPUT one or more times to select the
video mode you want. You can select TV,
Composite, S-Video, VGA, Component,
HDMI, or DVD.
Using the TV
Selecting the TV signal source
To select the TV signal source:
1 Press MENU, then press CH+ or CH– one or
more times until the following menu opens.
2 Press VOL+ or ENTER, then press CH+ or
CH– one or more times to select Tuning
Band.
3 Press VOL+ or ENTER, then press VOL+ or
VOL– to select the TV signal source. You
can select Cable Auto, Air, Cable, Cable
HRC, or Cable IRC. If you use satellite TV,
select Air or Cable depending on the type of
satellite TV signal.
Memorizing channels
To select channels with the CH buttons, your
LCD TV/DVD combo needs to memorize
channels. When your LCD TV/DVD combo
memorizes channels, it scans for channels with
signals, then stores the channel information into
memory.
To memorize channels:
1 Press MENU, then press CH+ or CH– one or
more times until the following menu opens.
2 Press VOL+ or ENTER, then press CH+ or
CH– one or more times to select Auto Ch
Search.
Notes
If the picture quality is not good:
• Adjust the brightness and contrast.
• Change the PC’s video resolution.
• Change the refresh rate for the PC’s video
card. If you cannot change the refresh rate for
the video card, you may need to replace the
video card.