Filter
Top Products
31
Insignia NS-LTDVD19-09CA 19” LCD TV/DVD Combo
www.insignia-products.com
DVD
Specifications
Legal notices
Macrovision statement
This product incorporates copyright protection technology
that is protected by method claims of certain U.S. patents
and other intellectual property rights owned by Macrovision
Corporation and other rights owners. Use of this copyright
protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited
viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or
disassembly is prohibited.
Copyright
© 2008 Insignia. Insignia and the Insignia logo are
trademarks of Best Buy Enterprise Services, Inc. Other
brands and product names are trademarks or registered
trademarks of their respective holders. Specifications and
features are subject to change without notice or obligation.
For service and support call (877) 467-4289.
Stripes on picture Check for interference from other electronic
devices, such as radios and televisions, and
keep magnetic or electronic devices away from
your TV.
Bad stereo or
SAP sound
A long broadcast distance, or interference from
radio waves, can cause bad sound reception. If
so, change the mode to Mono.
Remote control
does not work
Remove obstacles between the remote control
and the player. Point the remote control at your
TV's IR sensor. Install fresh batteries.
"Input Signal Out
of Range"
appears on the
screen
Check the resolution and frequency of your
computer, and adjust it to the optimum
resolution for this TV: 1440×900 at 60Hz.
“No Signal”
appears on the
screen
Make sure that the cable is firmly connected to
the computer and TV.
Image is not clear Adjust the phase control.
Image is not
centered
Adjust the horizontal control.
Picture has a few
bright or dark
dots
A few bright or dark dots on an LCD screen is
normal. It does not affect the operation of this
TV.
Problem Solution
No sound • Make sure that your TV or amplifier is
working correctly.
• Make sure that the amplifier is set to
receive DVD signal output.
No image • Make sure that your TV is working
correctly.
• Make sure the color system is set
correctly.
Bad sound
quality
• Make sure that the audio output mode is
set correctly.
• Make sure that the audio connection
between your TV and amplifier (if used)
is secure.
Disc cannot be
played
• Make sure that the disc is inserted with
the label facing forward.
• Clean the disc.
• Moisture has condensed in the player.
Remove the disc and leave the player on
for about an hour to dry out.
The player
doesn't operate
normally
Disconnect the power plug, then reconnect it.
Remote control
does not work
• Remove obstacles between the remote
control and the player.
• Point the remote control at your TV's IR
sensor.
• Install fresh batteries.
Problem Solution
LCD Panel 19" WIDE TFT LCD
Resolution 1440 × 900
Viewing angle 150°/135°
Contrast ratio 700:1(Typ.)
Brightness (cd/m
2
)
300 (Typ.)
Dimensions With stand 18.5 × 15.4 × 7.9 in.
(470 × 390 × 199.5
mm)
Without stand 18.5 × 13.8 × 2.7 in.
(470 × 350 × 69 mm)
Weight 15.48 lbs. (7.02 kg)
TV TV standard NTSC
Tuning system Electronic tuning
system
Frequency range VHF/UHF
Stereo BTSC
CATV 125 channels
Power Input 100-240V AC, 50/60 Hz
Consumption (Max.) 75 W
Sound Output 3W×2
Terminals A/V in Video, S-Video, Audio
L/R
Component Y, Pb (Cb), Pr (Cr)
PC in D-SUB 15-pin RGB in
HDMI HDMI compliant (type
A connector)
Antenna in F-type
DVD player Signal System NTSC
Playable discs DVD:12cm
CD:12cm
Operating
conditions
Temperature
Humidity
Atmospheric pressure
5°C~35°C
20%~80% RH
86KPa~106 KPa
08-1154 NS-LTDVD19-09CA - ENG.fm Page 31 Monday, April 28, 2008 10:03 AM