Filter
Top Products
GB 11
This procedure is necessary if your Mediamaster is con-
nected to the TV with an RF cable, and not via SCART.
To tune your TV to the RF signal you might also need your TV
manual in addition to this manual. The steps below explain what
to do if you have been unable to use SCART cables in your con-
nection.
• Plug in your Mediamaster.
Tuning your TV to the Mediamaster
• Select a channel number on the TV that is not currently used
for other TV channels.
• Follow the instructions in your TV manual to tune the TV chan-
nel selector to UHF channel 43 (this is the Mediamaster’s fac-
tory preset UHF channel). If you are already using this chan-
nel, select another non occupied UHF channel between 21 to
69 on the TV.
• For example, if you select UHF channel 45 on your TV, you
must change your Mediamaster to the same channel.
Use the
or buttons on the front panel of the Mediamaster,
or on the remote control, to change to the corresponding chan-
nel. You will see the UHF channel number displayed on the
front panel of the Mediamaster.
• When you have correctly changed the UHF channel number
you will see the ”
Welcome
” menu on the TV screen.
If there is interference from other channels you will have to
change the chosen UHF channel.
• Follow the instructions in your TV manual to store this UHF chan-
nel as the channel used by your Mediamaster. You will have to
select it when you want to watch digital TV/Radio channels.
• Once the welcome message is visible, press the OK button
on the Mediamasters remote control to start the “First time
installation” procedure, see next page.
If for some reason you have to change the RF channel later,
you can do this by using the TV settings menu further on in
this manual.
If you have a VCR connected it must be tuned to a different
UHF channel (between 21 to 69) than the Mediamaster.
Tuning procedure when RF connections are used
Switching on for the first time with SCART
connections
• Plug in your Mediamaster
• Now you will see the ”Welcome” menu on the screen.
• Press OK on the Mediamaster remote control to start the In-
stallation procedure.
You may now proceed to “First time installation”, see next page.
INSTALLATION OF THE MEDIAMASTER