Filter
Top Products
10
Programming Combo Device Codes
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc.) will
require you to set up two different Mode buttons to control both
parts of the Combo device. For example, if you have a TV/DVD
Combo, you might need to set up one code under the TV button to
control the TV part AND a separate code (under any other Mode
button) to control the DVD part.
Controlling Combo Devices
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc.) have
separate buttons on the original remote to select the part of the
Combo device to be controlled. For example, if your Combo device
is a DVD/VCR then its original remote might have separate DVD
and VCR buttons for selection of the Combo part you would control.
The equivalent button functions can be found on your new remote
by using the device Mode and SETUP buttons.
Referring to “Programming with Code Search” on page 8, setup
a device Mode (e.g. DVD) with the correct code for your Combo
device. Assuming the DVD/VCR Combo device is the example and
its code is programmed under DVD Mode, press and hold the DVD
Mode button for more than one second to send the DVD button
command. To send the VCR button command, quickly press and
release the SETUP button followed by pressing and releasing
the DVD Mode button. This method can be applied similarly to
all Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc.) and is
available for all Modes. Note this feature is not supported by all
codes.
Controlling Devices Requiring Separate Power On and Off
Buttons
Some devices (e.g. certain RCA TVs) require separate Power On and
Power Off buttons to turn the device on and off. The equivalent
button functions can be found on your new remote by using the
device Mode and ON-OFF buttons. Referring to “Programming with
Code Search” on page 8, setup a device Mode (e.g. TV) with the
correct code for your device.
Assuming a TV device is the example and its code is programmed
under TV Mode, to turn your TV on, press and hold the TV Mode
button for more than one second to transmit the Power On button
command.
Setup, cont.