Filter
Top Products
1918
To set the ITEM # for the Keyfob:
b. Enter setup mode as on the previous page (LED
flashing continuously).
c. Press a button (1 thru 6) to program the ITEM #.
The Keyfob beeps the number of times
corresponding to the ITEM #.
Important, if you used the default code of #1 for your
Remote’s item #, then you will need to set your
Keyfobs to something other than #1, i.e. 2 thru 6.
If you purchase additional keyfobs then simply
follow the steps above to set them up.
Using the FIND IT Remote to Find
Misplaced Items
To find an object with a missing FIND IT Locator
Keyfob attached, simply press FIND on your FIND
IT Remote, the Remote warbles and the LED lights
up, release FIND, then press the # key (1 thru 6)
corresponding to the missing unit.
If the object is in range, the FIND IT Locator Keyfob
on the missing object will begin to flash and beep.
You can use any Keyfob or Remote to locate any
other Keyfob or Remote.
The maximum distance the lost item can be from
the Remote is about 30 ft. Therefore, it may be
necessary to walk to various points in your home in
order for it to function.
3. Set the ITEM # for the Keyfob
FIND IT Locator Functions, cont. FIND IT Locator Functions, cont.
a. Remove the plastic tab from the
battery compartment. The
Keyfob beeps and immediately
goes into setup mode. The LED
blinks continuously to indicate
that the Keyfob is ready to be
set up. To enter the setup
mode at any other time, press
and hold the 1 and 3 buttons
simultaneously for about 3
seconds. A warble beep is
emitted and the LED flashes
continuously.
To Replace the Battery:
• Open the battery compartment on the back.
• Insert the battery with the “+” (positive) side up.
• Close the battery compartment.
The Keyfob beeps and immediately goes into setup
mode. The LED flashes continuously to indicate that
the Keyfob is ready to be set up. Please see
Setting the ITEM # on the next page.