Filter
Top Products
41
Auto Tuner Setup
The auto tuner setup function is described on page 24 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M
ENU button
π†
To "Tuner Setup"
è
To enter
π†
To "Auto Tuner Setup"
è
To enter
è
To choose "Cable" or "Air"
π†
To "Scan Mode"
è
To choose "Auto", "STD", "HRC" or "IRC"
†
To "Start"
Press the OK button (Programming will take serveral minutes)
The auto tuner is finished when the message "Programming Over !" appears onscreen.
BACK
Back
MENU
ExitSelect Operate
Tuner Setup > Auto Tuner Setup
Tuner Mode
Scan Mode
Air
Auto
Start
–
+
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the MENU button on the side of the TV
instead of the remote control. Choose "Auto Tuner Setup" by pressing MENU
†
on the side
panel and enter by using the CHANNEL +/- (
è
) buttons.
Tuner Setup
LCT2275-001B-A English.indd 41LCT2275-001B-A English.indd 41 6/14/07 10:34:20 AM6/14/07 10:34:20 AM