Filter
Top Products
76
Playback does not start or stop immediately
after playback is started by pressing :.
On the front display panel, “NO DISC”
appears.
• The disc is loaded upside down.
A Place the disc on the disc tray with the playback surface
facing down.
• A disc not being compatible with the unit is loaded.
A Load a playable disc on the unit.
• A dirty disc is loaded.
A Clean the disc.
• Defective disc is loaded.
A Replace the warped or scratched disc with a normal one.
Images are blurred or distorted when you
start High-Speed Search.
A Images are blurred or distorted at the point where the
playback speed changes and this is not a malfunction of the
unit.
Playback does not start.
A Playback does not start for approximately 30 seconds after
recording is stopped and this is not a malfunction of the unit.
Before requesting service for a problem, use this chart and see
if you can solve the trouble yourself. Small problems are often
easily solved, and this can save you the trouble of sending your
unit off for repair.
General
No power is supplied to the unit.
• The AC power plug is disconnected from the AC outlet.
A Connect the AC power plug to the AC outlet securely.
Recording
Recording from the external equipment is not possible.
• The source has not been properly connected.
A Confirm that the source is properly connected.
• All necessary power switches have not been turned on.
A Confirm that all units’ power switches are turned on.
• The setting of the input select position is inappropriate.
A Select the input in the menu that corresponds to the input
terminal connected to the external equipment.
Recording cannot be made.
• No disc or a disc not being recordable with the unit is loaded.
A Load a recordable disc on the unit.
• A finalized disc is loaded.
A Recording cannot be made on finalized discs. Load a
recordable disc on the unit.
• The disc is full or does not have enough space for the title to
be recorded.
A Clear unnecessary titles on the disc or load a blank disc.
Playback
Images do not appear on the monitor screen.
• The monitor input selector is not set to an input signal.
A Set the input select to an appropriate position.
Others
Troubleshooting
77
Service and Claims
If service is needed either during or after the warranty period:
1. Contact Stryker Endoscopy at 1-800-624-4422 or phone your local Stryker Endoscopy sales representative.
2. Clean and sterilize all parts that will be returned for service. Follow the instructions provided in this manual.
3. Package all the components carefully in the original shipping container if possible.
4. Ship the DVD recorder, pre-paid and insured to:
Stryker Endoscopy Customer Service
Attention: Repair Department
5900 Optical Court
San Jose, CA 95138
Stryker and Stryker Endoscopy are registered trademarks of Stryker Corporation.