Filter
Top Products
E-49
PLAYBACK
–
Selecting playback audio output
–
The output mode for audio playback can be selected with the remote controller.
DISPLAY
BARS
MENU SEARCH+
SEARCH–
A.DUB
F.RE V
INDEX– INDEX+
PLAY
STOP
REMOTE CONTROL UNIT
RM-G3000
REW FF
PAU SE
SET
BLANK
STILL
MODE
AUDIO
MUTING
OUT SEL.
OUT LEV.
REC
F.ADV
AUDIO MUTING
button
OUT SEL.
button
OUT LEV.
button
Memo
• The output channel for playback audio of
tapes recorded in the 32kHz mode can also
be set via the AUDIO OUT SEL item of the
AUDIO/VIDEO menu of the main unit.
• The audio output level can be set via the
AUDIO OUT LEVEL item of the AUDIO/
VIDEO menu.
(
☞
Page 61 “AUDIO/VIDEO menu”)
Ⅵ To turn the audio muting function ON/
OFF or to mute the EE audio, press the
AUDIO MUTING button.
To resume the audio output, press the button
again.
Ⅵ Selecting the audio output channel for
playback of tapes recorded in the 32kHz
mode.
Each time the OUT SEL. button is pressed, the
channel changes in the following sequence:
• CH3/CH4: CH3 audio is output via the CH1/3
AUDIO OUT terminal whereas CH4 audio is
output via the CH2/4 AUDIO OUT terminal.
• MIX: Sounds mixed from CH1 and CH3 are
output via the CH1/3 AUDIO OUT terminal
whereas Sounds mixed from CH2 and CH4 are
output via the CH2/4 AUDIO OUT terminal.
CH1/CH2 CH3/CH4 MIX
Note
Depending on the sound source, noise may
occur in the MIX mode. In this case, please
use CH1/CH2 or CH3/CH4.
Ⅵ Select the output level for audio play-
back
Each time the OUT LEV. button is pressed, the
standard level for the output audio level changes.
(NORMAL or ATT)
•To play back tapes recorded at a standard level
of –12dB (using a consumer DV device), set
the output level to ATT. In so doing, the audio
output level decreases.
•To play back tapes recorded on this unit, set
the output level to NORMAL.
BR-DV3000_E_p03-49 06.8.24, 1:39 PM49