Filter
Top Products
12
On the Status Display
If you press the INPUT SELECT button (☞ t on page 10) currently lit, the status of the input signal and setting of MUTING are displayed for about
3 seconds.
● Make the setting to display/hide the status in “STATUS DISPLAY” of the “INFORMATION.” (☞ page 21)
● When “STATUS DISPLAY” is set to “AUTO” or “ON,” the status below is also displayed in the following cases:
– When you change the input
– When the signal condition of the current input changes
– When you turn on the monitor
● When “STATUS DISPLAY” is set to “ON,” the signal format will remain displayed 3 seconds after the status is displayed.
1 Signal format
● For the contents displayed, see “Available signals” on page 29 and “On the signal format” below.
On the signal format
The following messages appear depending on the type of input signals and their conditions.
When a DVI-D signal protected with HDCP is input
“*” (at the end of the indication)
When no video signal comes in
“NO SYNC”
When a noncompliant video signal comes in
“Out of range”
➔
➔
➔
2 Signal format of DVI input
☞ On page 20 “DVI INPUT SEL.”
Status indication of DUAL LINK/3G SDI signal information
● “DUAL LINK” appears when the MAIN MENU “SDI DUAL LINK” (☞ page 14) is set to “ON” in SDI input, and the 3G SDI signal information
appears when the MAIN MENU “SDI DUAL LINK” is set to “OFF.”
Status indication of 3G SDI signal information
Following signal information can be displayed when a 3G SDI signal comes in.
3G A-1: Level A mapping structure 1
3G A-2: Level A mapping structure 2
3G A-3: Level A mapping structure 3
3G A-4: Level A mapping structure 4
3G B-DS1: Level B data stream 1
3G B-DS2: Level B data stream 2
3G B-DUAL: Level B DUAL LINK
3 Displaying the SDI FORMAT setting
● “SDI FORMAT” in “SET-UP MENU” appears. (☞ page 20).
4 Setting of “MUTING”
● Displayed only when muting is activated (☞ 5 on page 9).
Daily Operations (cont.)