Filter
Top Products
13
Menu Operations
1 Display the menu.
To display the MAIN MENU
Press MENU button.
To display the SET-UP MENU
Press
button while holding button.
2 Press buttons to select an item, then press button.
● For some items, adjustments will be made by pressing .
3 Press buttons to select an item, then press buttons to make adjustments.
4 Press MENU button to finish the menu operation.
● Pressing MENU button repeatedly deactivates the display of the menu.
Menu Transition Diagram
MAIN MENU
PICTURE FUNCTION
BACK LIGHT
MARKER
AUDIO SETTING
SYNC FUNCTION
3G SDI LEVEL B
SDI DUAL LINK
SCOPE SETTING
APERTURE
APERTURE LEVEL
CTI
LTI
I/P MODE
sub menu
reset
BALANCE
E.AUDIO GROUP
LEVEL METER SETTING
LEVEL METER ch
BAR TYPE
REFERENCE LEVEL
OVER LEVEL
BAR BRIGHTNESS
PEAK HOLD
AREA MARKER
MARKER ASPECT
SAFETY MARKER
SAFETY AREA
FRAME
CENTER MARKER
LINE BRIGHTNESS
R-AREA MARKER
R-MARKER ASPECT
R-SAFETY MARKER
R-SAFETY AREA
NO SYNC ACTION
DELAY TIME
LOW LATENCY
CLOSED CAPTION
CLOSED CAPTION
DATA FORMAT
DECODE CH
GAIN
SIZE
POSITION
TRANSPARENT
AUTO OFF
WAVE DISPLAY
WAVE FILTER
WAVE OVER LEVEL
MARKING
LEVEL
FUNCTION SETTING
PICTURE SUB ADJ.
SIZE/POSI. ADJ.
WHITE BALANCE SET.
REMOTE SETTING
INFORMATION
CONTROL LOCK
DVI INPUT SEL.
SDI FORMAT
all reset
SET-UP MENU
GAMMA
COLOR TEMP.
R DRIVE
G DRIVE
B DRIVE
R CUT OFF
G CUT OFF
B CUT OFF
sub menu
reset
1st START
WORK TIME
CONTRAST
BACK LIGHT
OSD CONT.
SIDE MASK
reset
EXCUTE
SETTING
CANCEL
STATUS
START AFTER
sub menu POSI.
COLOR SYSTEM
TALLY SELECT
DIMMER
COMPONENT PHASE
LCD SAVER
CONTRAST
BRIGHT
CHROMA
PHASE
NTSC SETUP
COMPO. LEVEL
sub menu
reset
H SIZE
H POSITION
V SIZE
V POSITION
sub menu
reset
POSITION
SOURCE ID
CHARACTER SET.
STATUS DISPLAY
TIME CODE
CRC ERROR
SUB HOUR METER
MODEL
VERSION
HOUR METER
SERIAL TYPE
PARALLEL TYPE
PIN1
PIN2
PIN3
PIN4
PIN5
PIN6
PIN7
PIN8
● The menu automatically disappears in about 30 seconds after the previous operation.
● Some items may not appear on the menu depending on the input or the input signal.
● The items controlled by the MAKE system do not appear on the menu.
➔
➔
Setting the menu
MAIN MENU
MAIN MENU
Ex. When “MARKER” is
selected.
Item being
selected
Operation
guide
SET-UP MENU
* U.S.A. Only