JVC HD-65S998 Projection Television User Manual


 
80
WARNING!
Remember it is very important that YOU DO NOT TOUCH THE LAMP SURFACE. Please
read the warnings on page 78 again.
Also, replace the lamp with part number PK-CL120U only! The television is designed
to work specifically with this lamp. Lamps other than PK-CL120U may cause
malfunctions and/or other damage to the television.
To purchase a replacement lamp kit, please call 1-800-252-5722.
NOTICE (for USA)
This product has a High Intensity Discharge (HID)
lamp that contains mercury. Disposal of these
materials may be regulated in your community due
to environmental considerations. For disposal or
recycling information, please contact your local
authorities or for USA, the Electronic Industries
Alliance: http://www.eiae.org
5) Install the new lamp unit.
Holding the handle attached to the new lamp unit, slide and push the new lamp into the
television and back into the lamp housing area. Do not forget to re-tighten the two screws.
Note: If the lamp does not sit securely in the TV (in the lamp housing area), it won’t turn on.
Make sure the lamp sits securely in the housing area.
6) Re-install the lamp cover.
Insert the lamp cover in the right concave and close the lamp cover. Because the lamp cover
has a role to help prevent the danger of an electrical shock, tighten the screw using a Phillips
head type screwdriver (cross-head type).
Notes:
• Make sure the lamp door is closed completely, or the power will not turn on.
• After installing the new lamp unit, do not forget to reset the lamp timer. See page 59.
4) Remove the lamp unit.
Using a Phillips head type screwdriver (cross-head type), loosen the two screws fastening the
lamp unit. When the screws have been loosened, remove the lamp by raising the handle and
gently sliding the unit towards you. Place it carefully in the recycling packaging.
Lamp Replacement
T
LCT2172-001C-A English.indd 80LCT2172-001C-A English.indd 80 3/26/07 8:59:33 AM3/26/07 8:59:33 AM