Filter
Top Products
56
Repeat Playback
Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
● The Play indicator ( ) on the display panel blinks
slowly.
● The tape plays 50 times automatically, and then stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTES:
●
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
●
For a cassette recorded in D-VHS mode, Repeat Playback is
possible only if the cassette was recorded in STD mode.
NTSC Playback
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LOAD A CASSETTE
1
Insert a cassette recorded in NTSC.
START PLAYBACK
2
Press PLAY.
● "NTSC→PAL" appears on the screen for about 5
seconds.
● Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
● The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
● The counter and tape remaining time readings will be
incorrect.
● During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
● Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
ADVANCED OPERATIONS (cont.)
123
456
789
1
2
1
2
3
– –:– –
0
3
4
4
FF
REW
STOP
PAUSE
PLAY