JVC HR-470 VCR User Manual


 
Filename [HRJ670EU3.fm]
Masterpage:Left
52
EN
TROUBLESHOOTING (cont.)
OTHER PROBLEMS
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Whistling or howling is heard from the
TV during camcorder recording.
The camcorder’s microphone is too
close to the TV.
Position the camcorder so its microphone
is away from the TV.
The TV’s volume is too high. Turn the TV’s volume down.
2. When scanning channels, some of
them are skipped over.
Those channels have been designated to
be skipped.
If you need the skipped channels, restore
them (
pg. 42).
3. The channel cannot be changed. Recording is in progress. Press
9 to pause the recording, change
channels, then press
4 to resume
recording.
4. Channel settings that were made
manually seem to have changed or
disappeared.
After the manual settings were made,
Auto Channel Set was performed.
Perform manual setting again.
5. No channels are stored in the
recorder’s memory.
The TV aerial cable was not connected
to the recorder when Auto Set Up was
performed.
Connect the TV aerial cable to the
recorder properly and turn off the recorder
power once, then turn the recorder power
back on again. The recorder will try Auto
Set Up again (
pg. 8).
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch
the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After
checking the cassette, operate the unit as usual.
HRJ670EU3.fm Page 52 Friday, February 11, 2000 3:30 PM