Filter
Top Products
50 EN
EDITING (cont.)
Edit To Or
From Another
VCR
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the player’s VIDEO OUT
and AUDIO OUT connectors and the recorder’s VIDEO
IN and AUDIO IN connectors.
● When using your VCR as the recorder and a monaural
VCR as the player, connect the player’s AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER’S INPUT
MODE
3
Set to AUX. With this VCR, press NUMBER key “0” (AU
appears on the front display panel in place of a channel
number).
NOTE:
When using this VCR as the recorder, make sure to select
"FRONT" or "REAR" (depending on which input connectors
you use) at the Aux Input Screen. (To select the correct AUX
input connector, follow steps 4, 5, 9 – 11 from the "Edit
From A Camcorder" section,
੬
pg. 48.)
START PLAYER
4
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY (
੬
pg. 28).
START RECORDER
5
Set to its record mode.
NOTE:
If you use an auxiliary input to connect a cable box or DBS
receiver make sure that the correct input ("FRONT" or "REAR") is
selected after you have finished editing (
੬
step 10, page 49).
Player
Audio/Video cable
(supplied)
VIDEO IN
AUDIO IN
Another VCRRecorder
Your VCR
AUDIO OUT
VIDEO OUT
3
¶78
1
¡
1
2
3
456
7
8
0
9
NUMBER "0"