Filter
Top Products
EN 23
VIEW CONFIRMATION
SCREEN
4
After "SCAN COMPLETED"
is displayed on the screen
for about 5 seconds, the
Confirmation screen
looking like the one to the
right appears. The stations
your recorder located
appear on a Confirmation
screen — channel
positions (PR) and
channels (CH).
The blueback screen and the program currently being
broadcast by the blinking station appear alternately for
8 seconds each.
To view the next page, use the %fi button on the
remote control.
RETURN TO NORMAL
SCREEN
5
Press MENU.
● Using the Confirmation screen, you can skip or add
channel positions, enter station names and perform
other operations. Refer to pages 24 – 26 for the
procedures.
PR CH ID PR CH ID
01 25
– – – –
07 C33
– – – –
02 C08
– – – –
08 C26
– – – –
03 10
– – – –
09 55
– – – –
04 C65
– – – –
10 C24
– – – –
05 C31
– – – –
11 C23
– – – –
06 C32
– – – –
12 C25
– – – –
[
5
∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
IMPORTANT
Your video recorder memorizes all detected stations even if
reception of some of them is poor. In these cases picture
quality may be poor. To delete those stations with an
unacceptable picture ੬ "Delete A Channel" on page 25.
NOTES:
●
Fine tuning is performed automatically during Auto Channel
Set. If you want to perform it manually, refer to page 25.
●
If you perform Auto Channel Set when the aerial cable is not
connected properly, "SCAN COMPLETED -NO SIGNAL-"
appears on the screen in step 4. When this happens, make
sure of the aerial connection and press OK; Auto Channel Set
will take place again.
C: Cable
123
456
7
89
0
2
4
1
3
?
OK
MENU