Filter
Top Products
26 EN
SUBSIDIARY SETTINGS (cont.)
%
SELECT STATION NAME
CHARACTER
1
Press until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press %fi to cycle through the characters (A–Z, 0–9, –,
*
, +, (space) ) and stop when the desired character
is indicated, then press to enter. Enter the remaining
characters the same way (maximum of 4).
After entering all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press until the incorrect
character begins blinking. Then enter the correct
character by pressing
%fi
.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
[
%
%
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 24 to access the Confirmation screen before continuing.
SELECT ITEM
1
Press
%fi
until the item you want begins blinking.
ACCESS MANUAL
CHANNEL SET SCREEN
2
Press OK twice.
SELECT NEW STATION
3
Press until the station
name (ID) begins blinking,
then press
%fi
until the
new station’s name (ID)
you want to store begins
blinking.
Registered station names
(੬ pg. 27) appear as you
press
%fi
.
SWITCH STATIONS
4
Press OK.
● The Confirmation screen appears.
● Repeat steps 1 through 4 as necessary.
CLOSE CONFIRMATION
SCREEN
5
Press MENU.
Set Stations (A)
Set station names that are registered in your recorder.
%
Perform steps 1 and 2 of "Storing Channels Manually" on
page 24 to access the Confirmation screen and then perform
step 1 and 2 of "Set Stations (A)" on the left before continuing.
Set station names other than the ones registered in your recorder.
PR CH ID FINE
06 CH45
– –␣ – –
+/–
[
5
∞
] : CHANGE ID
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞
PR CH ID FINE
06 CH45 ARD +/–
[
5
∞
] : A-Z, 0-9
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞
∞