Filter
Top Products
8 EN
INITIAL SETTINGS (cont.)
SET CLOCK
AUTOMATICALLY
3
At the Clock Set screen,
press PUSH JOG . The
Auto Clock screen appears
and clock setting begins.
● If "TV PR." isn't set to the
channel position on
which Auto Clock data
is received, "ERROR"
appears, and then the screen from step 2 reappears.
To set "TV PR.", press OK to place the pointer next to
it, then cycle through the numbers by pressing PUSH
JOG%fi until the number representing the channel
position in which the station transmitting clock
setting data is stored appears.
RETURN TO NORMAL
SCREEN
4
Once clock setting is completed, press CLOCK to return
to the normal screen.
Auto Clock Set
AUTO CLOCK
PLEASE WAIT
JUST CLOCK: ON
TV PR. 1
%
SET DATE AND TIME
3
Press PUSH JOG%fi to set the hour, then press OK. The
“minutes” display begins blinking. Repeat the proce-
dure to set the minutes, day, month and year.
SET JUST CLOCK
4
The default setting is “ON”. Set as desired by pressing
PUSH JOG%fi, then press OK.
● If you set to “OFF”, you can disregard the next step as
you won’t be able to receive regular clock adjust-
ments.
SET CLOCK DATA SOURCE
CHANNEL POSITION
5
The recorder is preset to receive clock setting and
adjustment data from channel position 1. Press PUSH
JOG%fi to set the channel position to the number
representing the station transmitting clock setting data,
then press OK.
START CLOCK OPERATION
6
Press CLOCK.
6
q
12
45
3
6
8
0
7
9
1
3
2
OK
Manual Clock Set
NOTES:
●
Auto Clock and Just Clock require a PDC signal, and will not
operate with a VPS signal.
●
Just Clock (when set to "ON") enables adjustment of the
recorder's built-in clock every hour on the hour, except for 11
o'clock in the evening and midnight.
●
Just Clock is not effective when . . .
– the recorder’s power is on (unless the recorder is tuned to
the same channel position selected in the Clock Set screen).
– the recorder is in the Timer mode.
– a difference of more than 3 minutes exists between the
built-in clock’s time and the actual time.
●
If Just Clock is set to "ON", the recorder’s clock is automati-
cally adjusted at the start/end of Summer Time.
●
Auto clock setting and Just Clock may not function properly
depending on the reception condition.
●
During Manual clock setting, if the day and month data are
invalid (such as 31st April), the month digits are cleared
automatically and the day digits begin blinking. Input the
correct data.
●
If, in step 3 of the Manual clock setting procedure, the year
digits are automatically cleared and the day digits begin
blinking, it is possible that you have input 29th February for a
non-leap year. Input the correct data.
CLOCK
PUSH JOG