Filter
Top Products
three-step quick start10
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the batteries into
the Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
REVIEW
VCR
SAT
REVIEW
VCR
SAT
Three-Step Quick Start
Auto Setup
START AUTO SETUP
Press the o button. If ‘Auto’ appears on the display panel, press OK (or E).
what will happen?
The display panel on the front of the VCR will show the word
‘Auto’. Do not press any button on the VCR or the Remote Control.
note If you have connected both the RF cable and the fully-wired 21-pin SCART cable,
and if your TV offers T-VLink, etc., and the TV is turned on, the VCR automatically
performs the Preset Download (੬ pg. 11) even if you select ‘Auto’ for Auto Setup function.
The VCR is automatically setting up the tuner
channels, clock, the VIDEO Plus+ assigned
Guide Program numbers and the video
channel. This only happens the first time that
the VCR is turned on.
rf and scart connection If you have chosen
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided)
and the TV set is in its AV mode (see the TV
manual), you will see the following information
displayed on your TV screen:
SELECT THE VIDEO CHANNEL
When
Auto Setup has finished, you will see the following display panel on your VCR:
rf cable only If you have only used the RF
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
the TV that the
Auto Setup has chosen to be the
video channel. In the example, we have presumed that channel 36 is vacant and
have set the VCR to 36:
Now tune the TV set to channel 36 (refer to TV manual if neces-
sary); you should see two vertical white bars appear on the TV
screen. If the bars do not appear or are not clear, choose another
vacant channel and try again. If you cannot obtain the vertical
white bars on any channel between 22 and 69, consult your local
JVC dealer.
rf and scart connection If you have chosen
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided),
you need to press the
PR button on the Remote
Control until the figure reads ‘– –’. This is because you will use the TV in AV mode
to view video pictures and therefore do not need a dedicated video channel.
For Step , be sure to perform either of the methods:
Auto Setup or Preset Download.
T
V
P
R
+
T
V
P
R
–
T
V
–
T
V
+
TV
0000
STOP
FIN
MENU
OK
TV/VCR
DAILY/QTDN.
VPS/PDC
AUX
?
WEEKLY/HEBDO
PROG
30 SEC
– –:– –
AUDIO
12
3
4
65
7
8
9
0
DATE
START
DEBUT
PR
2
4
1
3
E
N
T
E
R
/
E
N
T
R
E
E
EXPRESS
P
R
+
OK
3
E
N
T
E
R
/
E
N
T
R
E
E
– –:– –
O
TE PR
AUTO SET
PLEASE WAIT
[MENU]: EXIT
Auto Setup is running: don’t
touch any buttons
Your TV screen during Auto Setup if SCART is used
REVIEW
VCR
SAT