JVC HR-J7005UM VCR User Manual


 
EN 23
0
4
1
3
Recording
Perform steps 13 on page 13 ("Simple Recording") before
continuing.
ATTENTION
As B.E.S.T. takes place before recording actually starts,
there is a delay of about 7 seconds after REC and PLAY on
the remote, or REC on the VCR's front panel, are pressed.
To make sure you record the desired scene or program
completely, first perform the following steps:
1) Press and hold PAUSE, and press REC to engage the
RECORD PAUSE mode.
The VCR then automatically checks the condition of
the tape and, after about 7 seconds, re-enters RECORD
PAUSE.
2) Press PLAY to start recording.
If you want to bypass B.E.S.T. and start recording right
away, set "B.E.S.T." to "OFF" in step 4 of the Preparation
procedure ( pg. 22).
START PLAYBACK
1
Press PLAY.
The VCR adjusts the
playback picture quality
based on the quality of
the tape in use.
NOTES:
When using rental tapes,
or tapes recorded on other VCRs, set “B.E.S.T.” in step
4 of the Preparation procedure to either “ON” or
“OFF” as desired to give the best picture (
pg. 22).
The B.E.S.T. Picture System screen only appears at the
beginning of automatic tracking. Even though the
screen doesn't appear after that, the B.E.S.T. function
is operative.
To display the B.E.S.T. Picture System screen,
“SUPERIMPOSE” must be set to "ON" or the B.E.S.T.
Picture System screen will not appear (
pg. 19).
START RECORDING
1
Press and hold REC and
press PLAY on the remote
control, or press REC on
the VCR's front panel.
The VCR takes about 7
seconds to assess the
quality of the tape in
use, then recording
begins with the picture
level optimized.
NOTES:
B.E.S.T. occurs immedi-
ately prior to both the
first SP and the first EP
recording after inserting
the cassette. It does not
take place during
recording.
In the case of timer
recording, B.E.S.T. takes
place for both SP and EP before the first timer recording
after inserting the cassette (regardless of the tape speed
selected for that recording).
Once the cassette is ejected, the B.E.S.T. data is
canceled. The next time the cassette is used for
recording, B.E.S.T. is re-performed.
While B.E.S.T. is operative, the PAUSE button will not
function.
To display the B.E.S.T. Picture System, "SUPERIM-
POSE" must be set to "ON" or the B.E.S.T. Picture
System screen will not appear (
pg. 19).
Playback
The VCR assesses the quality of the tape once you start
playback.
Perform steps 1 and 2 on page 12 ("Simple Playback") before
continuing.
B.E.S.T. PICTURE SYSTEM
START END
B.E.S.T. PICTURE SYSTEM
+
+
+
+
DURING B.E.S.T.
B.E.S.T. COMPLETE
START END
B.E.S.T. PICTURE SYSTEM
+
+
+
+
PAUSE
PLAY
REC
PLAY
PAUSE
REC