Filter
Top Products
EN 25
Basic
Recording
Select recording channel
a– Press CH + or –.
or
b– Press the Number keys.
● If you connect the TV and the VCR only using
the RF connection, press TV/VCR on the Remote
so that the VCR mode indicator lights on the front
display panel, to view the program to be recorded.
Set tape speed
Press SP/EP to set the recording speed.
Start recording
On the front panel:
Press REC ( ¶ ).
On the Remote:
While holding REC ( ¶ ), press PLAY ( 3 ).
● If “VIDEO CALIBRATION” is set to “ON”
(default setting: ੬ pg. 40), this VCR checks the
tape condition for about seven seconds, then
starts recording. This means that the first seven
seconds of the program will not be recorded. If
this is inconvenient for you, follow the steps
below:
Press REC ( ¶ ) and PAUSE ( 8 ) to start
Video Calibration.
Then press PLAY ( 3 ) to start recording
after Video Calibration is complete.
To pause recording
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
To stop recording
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ).
To fast-forward the tape (when it is not running)
Press FF ( ¡ ).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette with the VCR turned off.
To turn off the VCR
Press POWER.
It may be unlawful to record or play back
copyrighted material without the consent of the
copyright owner.
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
This VCR can check the tape condition during recording
(and playback), and realizes the best possible pictures.
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
123
456
7
89
0
2
4
1
3
STOP ( 7 )
FF ( ¡ )REW ( 1 )
–a
–b
POWER
PAUSE ( 8 )
TV/VCR
PLAY
REW
FF
REC PAUSE STOP/EJECT
+
S-VHS ET
CH
REC LINK
VIDEO (MONO)L—AUDIO—R
STOP/EJECT
( 7 / 0 )
PAUSE ( 8 )
PLAY ( 3 )
POWER
REW
(1)
FF
(¡)