Filter
Top Products
EN 51
This Remote can control some functions of the DBS
(Direct Broadcast Satellite) receivers listed below.
Turn on the DBS receiver
Turn on the DBS receiver using the Power button
on the DBS receiver or its Remote.
Enter DBS receiver brand code
Follow the example shown below.
Press and hold CABLE/DBS.
Press MBR SET.
Press the Number keys to enter your DBS
receiver’s brand code by referring to the table
below.
Press OK, and release CABLE/DBS.
The DBS receiver should turn off. If it does, try
other operations below (੬ step ).
● Once you have set the Remote to operate the
DBS receiver, you do not have to set it until you
replace the batteries from the Remote.
Operate DBS receiver
While holding down CABLE/DBS, press one of
the following buttons: POWER, TV CH +/–, and
Number keys.
● For some brands, you must press ENTER after
having pressed the Number keys to enter a
channel number.
● To change the DBS receiver’s channels, press
TV CH +/– or the Number keys. (The CH +/–
button can be used to change the VCR’s
channels only.)
DBS BRAND NAME BRAND CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
PRIMESTAR 50
SONY (DSS) 41
RCA (DSS) 40
NOTES:
●
Depending on the type of DBS receiver, some or all functions
cannot be operated using this Remote.
●
It’s not possible to operate a DBS receiver not equipped with
a remote sensor.
●
It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the
Remote to operate one of these units at a time.
123
456
7
89
0
2
4
1
3
–
–
Number
TV CH +/–
–
POWER
ENTER
CABLE/DBS
–
(Ex.) To set the Remote to JVC 51:
Release
Hold
down
Press in succession
DBS Receiver
Brand Setting
5
CABLE/
DBS
MBRSET
A/B
1
OK
3
E
N
T
E
R
/
O
S
D