Filter
Top Products
26
AV1 IN/OUT
AV2 IN
AV1 OUT
COMP. Y/C
R
L
AUDIO
PAUSE
ANT. IN
RF OUT
OUT
S OUT
DECODER VCR TV
EXT.2 EXT.1
This facility allows you to record automatically a satellite programme which is timer-programmed on your external satellite receiver.
Connect a satellite receiver to the recorder's AV2 IN connector and programme the timer on the satellite receiver; the recorder starts
recording when the signals input from the satellite receiver to the AV2 IN connector, and when there is no input signals the recorder
stops recording and the power shuts off.
Automatic Satellite
Programme Recording
NOTE:
Refer to the instructions supplied with your satellite receiver.
Mains outlet
TV Aerial cable
Aerial connector
Satellite Receiver Unit
Satellite Cable
Outdoor Unit
Aerial
Back of TV
21-pin AV input
connector (SCART)
RF OUT
ANT. IN
Back of Recorder
ADVANCED OPERATIONS (cont.)
AV1 OUT switch
IMPORTANT
Set "AV2 SELECT" to "SAT" on the Mode Set screen in step 3 of page 27.
If you set "AV2 SELECT" to "SAT"...
● It is possible to view a satellite programme with the TV set to its AV mode even if the recorder's power is turned off as long as
the recorder is
not in the Timer mode.
● The AV2 IN connector's input is the same signal that is controlled by the rear panel AV1 OUT switch as shown below:
a- If both the satellite receiver and the TV are compatible with the Y/C signal, set the AV1 OUT switch to Y/C in order to take
advantage of high-quality S-VHS pictures.
b- If the satellite receiver and/or the TV are/is not compatible with the Y/C signal, set the AV1 OUT switch to COMP.
AV2 SELECT setting on
the MODE SET screen
SAT
Rear panel AV1 OUT
switch
COMP.
Y/C
AV2 IN connector input
signal
Composite signal*
Y/C signal**
* The composite signal is a regular video
signal.
** The Y/C signal is a signal in which the
luminance and chrominance signals are
separated.