Filter
Top Products
29
ENTER PROGRAMME DATE
5
Press DATE +/–. (The current date appears on screen.
The date you enter appears in its place.)
● If you are using the Illumi-Guide feature, the following
buttons remain lit: START +/–, STOP +/–, DATE +/–,
TV PROG +/– and MENU.
ENTER PRESET POSITION
6
Press TV PROG +/–.
IMPORTANT
Be sure to confirm the setting of PDC recording.
●If " ON" is displayed on the screen or " " is lit
on the display panel, PDC is set to ON.
●If " OFF" is displayed on the screen or " " is
not lit on the display panel, PDC is set to OFF.
To change the setting, press : PDC (NUMBER
key "7").
੬ "PDC Recording" on page 28.
● If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: START +/–, STOP
+/–, DATE +/–, TV PROG +/– and MENU.
SET TAPE SPEED
7
Press SP/LP ( ) to set the tape speed.
RETURN TO NORMAL SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1 – 8 for each additional programme.
ENGAGE RECORDER’S TIMER
MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
8
••
•
•
••
••
•
•
•
••
•
•
••
••
•
•
•
SP
– P1 –
START STOP
21:00 = 22:00
SP
OFF
DATE TV PROG
25.12 1
BBC 1
[+/–] =
[MENU] : EXIT
Satellite Receiver Users
To timer-record a satellite broadcast using Regular Timer
Programming:
● Before you start step 1, be sure to set the recorder's input
mode to "AUX2" (੬ pg. 33). Do NOT change the input
mode until the selected programme has been timer-
recorded. In step 6, you have to select "AUX2" as well.
● Before the selected programme begins, select the
appropriate channel on the satellite receiver, and then
set the receiver's timer. If your satellite receiver does not
have a timer, leave the unit's power on.
TIMER
9
NOTE:
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen and "FULL" appears
on the front display panel. To record the extra programme, you
must first cancel any unnecessary programmes (
੬
pg. 30).
When Using The Illumi-Guide Feature
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU and re-perform the timer programming
procedure from the beginning.
● If for some reason the remote control's signal is not received
by the video recorder, press MENU and re-perform the timer
programming procedure from the beginning.
12
45
3
6
8
0
7
9
2
4
1
3
OK
WEEKLY
TIMER
: PDC
SP/LP
7
8
9
DAILY
TV PROG
6
DATE+/–
5
MENU
ILLUMI GUIDE