Filter
Top Products
Masterpage:Right-Full-NoTitle0
EN
25
Filename [HRS9700EU1a.fm]
Page 25 July 3, 2000 2:20 pm
TimeScan
* Still mode cannot be engaged using the remote control’s w or e button. Still mode can be engaged by pressing the 9 button.
**Smooth slow motion delivering an uninterrupted moving image without distortion.
● ±1/6x and ±1/18x search of EP recordings are not Time Jog.
● If the picture jitters vertically, noise appears or the upper or lower part of the picture is distorded at -1/2x, -1/3x, 1/3x, 1/2x or 1.5x
normal speed, use
PR +
or
–
to correct the picture.
● Noise may appear during TimeScan search, depending on the search speed.
● When noise appears or the upper or lower part of the picture is distorted during TimeScan, press
p and adjust tracking with
PR +
or
–
button.
● The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be distorted.)
● To resume normal playback, press
4.
● Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback once,
and then try using TimeScan again.
● The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with LP/EP
recordings.)
● Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP/EP
recordings, or depending on the tape being used.
● Picture may appear distorted in comparison to normal playback.
● When normal playback resumes from search (including TimeScan), still, slow motion or frame-by-frame playback, the picture may
jitter vertically momentarily depending on the type of TV being used.
● During TimeScan there will be a time lag between the video and the audio and noise may appear in the audio signal.
● TimeScan sound quality will differ in comparison to normal playback.
● When material such as music videos where there is non-stop sound (very few breaks in the soundtrack) are viewed at 1.5x or 2x
normal speed, the audio playback may be faster than normal.
● Depending on the type of tape contents, the sound may not be clear during forward slow-motion playback.
● Time Jog cannot be activated by pressing
9 for longer than 2 seconds.
● When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
● Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
● Time Jog does not work with NTSC playback.
● When playing back an NTSC tape, the speeds differ from those listed above and are not shown on the TV screen.
● TimeScan at -1/2x, 1/2x and 1.5x normal speed are not possible with a MESECAM tape.
● The operations by
JOG
dial/
SHUTTLE
ring do not include TimeScan. Noise will appear on the screen and audio will not be output.
Names of
special-effects
playback
Reverse Forward
Search Play
Slow-Motion
(Time Jog**)
*Still
Slow-Motion
(Time Jog**)
Play Search
Speed SP
-9x -7x -5x -3x -1x -1/2x -1/3x 0 1/3x 1/2x 1x 1.5x 2x 3x 5x 7x 9x
Speed LP
— -7x — -3x — -1/2x — 0 — 1/2x 1x 1.5x 2x — 5x — 9x
Speed EP
— -7x — -3x — -1/6x -1/18x 0 1/18x 1/6x 1x — 2x — 5x — 9x
Audio output
Audio is output.
Audio is not
output.
Audio is
output.
Audio is
output.
Audio is output.
If you do not want to hear TimeScan audio, set “TIME SCAN AUDIO” to “OFF”. (
੬
pg. 71)
HRS9700EU1a.fm Page 25 Monday, July 3, 2000 2:36 PM