Filter
Top Products
Masterpage:Right
EN
39
Filename [HRS9700EU2.fm]
Page 39 July 3, 2000 2:29 pm
REMOTE CONTROL FUNCTIONS
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A code
signals because your video recorder is initially set to respond to
A code signals. You can easily modify your video recorder to
respond to B code signals.
A
Remove the power supply.
Unplug the end of the mains power cord from the mains
outlet.
B
Set the remote control code.
Press and hold
VCR
on the remote control for over 2
seconds, press the
number key
“
2
” and then press
OK
.
C
Re-supply the power.
Plug the end of the mains power cord into a mains outlet.
D
Turn on the recorder.
Press
1
on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above, but in step
2
, press the
number
key
“
1
” instead of “
2
”.
HRS9700EU2.fm Page 39 Monday, July 3, 2000 2:37 PM