Filter
Top Products
Masterpage:Right-NoTitle0
EN
43
Filename [HRS9700EU2.fm]
Page 43 July 3, 2000 2:29 pm
C
Check the memory.
D
Return to the normal screen.
Press
MENU
.
Turn Off Navigation
If you do not want to record information on the programmes, set
“NAVIGATION” to “OFF”.
A
Turn off Navigation.
B
Return to the normal screen.
Press
MENU
.
NOTES:
● Video Navigation is possible with the cassettes recorded with
this recorder only.
● To record the date and time as the programme title in this
recorder’s memory, make sure the recorder’s clock is set
correctly before recording.
● To record the programme information in this recorder’s
memory, you must continue to record each programme for
over the minimum recording time; 8 minutes for the SP mode,
15 minutes for the LP mode or 23 minutes for the EP mode.
● Video Navigation may not work properly when an index code
(VISS signal) is marked or erased manually near a start point of
recorded programme. (
੬
pg. 22)
● Video Navigation may not work properly depending on the
tape being used.
● If the recorder finds two tape numbers in one tape while
playing back or searching for the beginning of a programme,
then when you remove the tape, the tape will be assigned just
one number (smaller number).
● The programme information is stored in this recorder’s
memory. If the memory in this recorder should ever be
damaged and the programme information lost, it is impossible
to restore that information.
● After recording a tape with this recorder, write the tape
number on a label and affix the label to the cassette in order to
allow you to find the tape by its number.
Press
rt
to move the
highlight bar (pointer) to
“CHECK MEMORY”, then
press
OK
.
● The CHECK MEMORY screen
will appear.
Perform steps
1
to
2
of “Check Memory” on page 42 before
continuing.
Press
rt
to move the
highlight bar (pointer) to
“NAVIGATION”, then press
OK
or
e
to set to “OFF”.
Video Navigation Title Screen
A Tape number
B Tape title
If there is no tape title entered, the earliest recording date
will be displayed.
C Current page number/total page number
D Largest blank space on the tape
(Calculated remaining time based on the current tape
speed (SP, LP or EP) selected on the recorder)
E Programme information
(Recording start time, date and channel number)
F Currently selected programme
G Current tape position
“*” is displayed if the currently selected programme and
the current tape position are different while tape is not
running.
H Detailed information of currently selected programme
(Recording start time, end time, recording length,
recording speed, programme title and category)
If there are no title and category entered, “TITLE” and
“CATEGORY” will be displayed.
HRS9700EU2.fm Page 43 Monday, July 3, 2000 2:37 PM