Filter
Top Products
19
Before Operation-DVD part
PREPARATION
LOCK (Parental Control)
Rating
Some movies contain scenes that may not be suitable for
children to view. Many of these discs contain parental
control information that applies to the complete disc or to
certain scenes on the disc. Movies and scenes are rated
from 1 to 8, depending on the area.
DVD video discs may or may not respond to the parental
control setting if the Area code of the disc is set wrongly.
Some discs offer more suitable scenes as an alternative.
Ratings are area dependent.
The parental control feature allows you to block access
to scenes below the rating you input, thereby preventing
your children from being able to view material you believe
is unsuitable.
1. Select “Rating” on the LOCK menu then press 1.
2. To access the Rating, Password and Area Code
features, you must input the 4-digit security code you
created.
If you have not yet entered a security code you are
prompted to do so. Input a 4-digit code and press
ENTER/OK. Enter it again and press ENTER/OK to
verify. If you make a mistake before pressing
ENTER/OK, press CLEAR ( ).
3. Select a rating from 1 to 8 using the 3/4 buttons.
1-8: Rating one (1) has the most restrictions and
rating eight (8) has the least restrictive.
Unlock: If you select unlock, parental control is not
active and the disc plays in full.
4. Press ENTER/OK to confirm your rating selection,
then press SETUP to exit the menu.
5. Press OPEN/CLOSE (<) to activate parental
control.
Note:
If you set a rating for the player, all disc scenes with the same
rating or lower are played. Higher rated scenes are not played
unless an alternate scene is available on the disc. The
alternative must have the same rating or a lower one. If no
suitable alternative is found, playback stops. You must enter the
4-digit password or change the rating level in order to play the
disc.
Password (Security Code)
You can enter or change password.
1. Select “Password” on the LOCK menu then press 1.
2. Follow step 2 as shown left column (Rating).
To change the password, select the “Change”, press
ENTER/OK and input the new 4-digit code then
press ENTER/OK. Input it again to verify.
3. Press SETUP to exit the menu.
If you forget your Security Code
If you forget your security code you can clear it using
the following steps:
1. Press SETUP to display the Setup menu.
2. Input the 6-digit number “210499” and the
security code is cleared.
3. Enter a new code as described above.
Area Code
Enter the Area Code whose standards were used to rate
the DVD video disc, based on the list in the reference
chapter (see page 36).
1. Select “Area Code” on the LOCK menu then press
1.
2. Follow step 2 as shown left (Rating).
3. Select the first character using 3/4 buttons.
4. Press 1 and select the second character using 3/
4 buttons.
5. Press ENTER/OK to confirm your area code
selection.
LOCK
Rating
New
DG
Unlock
Password
Area Code
Move
Select
DVD
DVD
VJ9033CP1Z_E-EZ.book Page 19 Friday, March 11, 2005 10:12 AM