Filter
Top Products
37
REFERENCE
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom Cause Correction
No power. • The power cord is disconnected. • Plug the power cord into the wall outlet
securely.
The power is on, but the
DVD+VCR does not
work.
• DVD or VCR button is not switched
properly.
• Refer to page 5.
• No disc is inserted.
• No tape is inserted.
• Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
No picture. • The TV is not set to receive DVD+VCR
signal output.
• Select the appropriate video input
mode on the TV so the picture from the
DVD+VCR player appears on the TV
screen.
• The video cable is not connected securely. • Connect the video cable into the jacks
securely.
• Mismatch setting between TV and this
unit.
• Select the correct Video Output in
SETUP menu.
• Wrong connection. • Check the connection.
No sound. • The equipment connected with the audio
cable is not set to receive DVD+VCR
signal output.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD+VCR.
• The audio cables are not connected
securely.
• Connect the audio cable into the jacks
securely.
• The power of the equipment connected
with the audio cable is turned off.
• Turn on the equipment connected with
the audio cable.
• The AUDIO options are set to the wrong
position.
• Set the AUDIO options to the correct
position.
The playback picture is
poor.
• The disc is dirty. • Clean the disc.
• The TV channels are not tuned in
properly.
• Check tuning, carry out tuning again.
• Tape heads are dirty. • Clean video heads.
• Tape is a rental or was recorded on
another VCR.
• Use PR/TRK (3/4) for manual
tracking adjustment while tape is
playing.
VJ9033CP1Z_E-EZ.book Page 37 Friday, March 11, 2005 10:12 AM