Filter
Top Products
19
3
Tuner setting
This DVD/VCR is equipped with a channel memory feature which allows channels to skip up or down to
the next channel set into memory, skipping over unwanted channels. Before selecting channels, they
must be programmed into the DVD/VCR’s memory. In addition to normal VHF and UHF channels, this DVD/
VCR can receive up to 113 Cable TV channels. To use this DVD/VCR with an antenna, set the TV/CATV
menu option to the TV mode. When shipped from the factory, this menu option is in the CATV mode.
Press SET UP MENU. The VCR menu screen will appear.
Press
or to select “CH SETUP”, then press ENTER.
Then press ENTER to select the
TV or CATV mode. The arrow
indicates the selected mode.
1
2
Press or to select the “TV/
CATV” option.
4
Press SET UP MENU until the menu screen is cleared.
TV - VHF/UHF channels
CATV - CABLE TV channels
2
Setting channels automatically
The VCR can receive a maximum of 181 channels by
presetting the channels into memory.
Then press ENTER.
The auto tuning will start. The
channel display will count up and
when finished, the screen returns
to normal.
1
Repeat above step 1 and press
or to select “AUTO CH
MEMORY”.
TV/CATV Selection
Turn ON the TV and set it to the video input mode.
Make sure TV/VCR/DVD switch has been slided to VCR/DVD.
Then press VCR to select the VCR mode. (The VCR indicator
will light.)
Preparation:
•
•
CH 002
You can not select "CH SETUP" if you
set the channel to "L".
NOTE:
2C31501AE(P16-21) 09/12/2002, 15:4019