Filter
Top Products
33
Stereo recording and playback/Separate Audio Program (SAP)
When a MTS STEREO broadcast is
received, the word “STEREO” will ap-
pear
on the screen for about 4 seconds
and the program can be viewed or re-
corded in stereo.
The Hi-Fi STEREO recording procedure
is the same as for normal recordings.
The VHS Hi-Fi audio system permits high fidelity recording of MTS
STEREO TV broadcasts.
NOTES:
• When playing back a tape that is not
recorded in Hi-Fi stereo mode, the
audio will automatically be monaural.
• When listening to a VHS Hi-Fi video
tape or MTS broadcast through the
VHF/UHF jack (Audio/Video cable not
connected), the sound will be
monaural.
Stereo Recording and Playback
NOTE:
When using a CATV system, stereo TV programs may be transmitted
over a mono cable channel. In this case the word "STEREO" will not
appear and the sound will be in mono.
When viewing an MTS STEREO TV program, or playing a prerecorded
VHS Hi-Fi STEREO videotape, press A.MONITOR to select how the
audio will be heard through the speakers. Normally set to the Hi-Fi
STEREO position, this button can be set to the MONO position if the
stereo broadcast or videotape audio is of poor quality. The "R" and "L"
positions allow the audio from the Right or Left Hi-Fi channel to be heard
over both TV speakers. This button has no effect when viewing a MONO
videotape or TV program. Each time when you press the button, OUTPUT
SELECTION display appears on the screen for several seconds. Refer
to the chart below.
Output selection
OUTPUT
SELECTION
STEREO
L ch
R ch
MONO
SOUND HEARD ON BOTH
SPEAKERS
STEREO
LEFT CHANNEL AUDIO
RIGHT CHANNEL AUDIO
MONO
Your VCR is fitted with a SAP broadcast system which enables
you to switch to a separate audio program when viewing a
selected channel.
This function applies only when the program is broadcast in
multi-languages through the SAP broadcast system.
Separate Audio Program (SAP)
Press SET UP MENU. Then press or to select “SAP”.
1
2
Then press ENTER
to select “ON”.
Then press SET UP MENU until
the menu screen is cleared.
When the VCR is turned on or a channel selection is made, make
certain the letters "SAP" appears on the screen for about 4 seconds.
This means that the "Separate Audio Program" broadcasting is
available.
Listening to SAP
OR
STEREO
STEREO SAP
SAP
2C31501AE(P28-33) 09/12/2002, 15:4133