Filter
Top Products
6
Setting up your TV
HV-32/28P37SJE / LCT1452-001A-U / ENGLISH
Rear Panel
1 Aerial socket (page 5)
2 EXT-1 terminal (pages 5, 36, 39)
3 EXT-2 terminal (pages 5, 10, 36, 39)
4 EXT-3 terminal (pages 36, 39)
5 EXT-4 terminal (pages 36, 39)
6 AUDIO OUT terminal (page 40)
Connecting the power cord to
the AC outlet
Caution
• Operate only from the power source specified
(AC 220 – 240 V, 50 Hz) on the unit.
Putting the batteries into the
Remote control
Use two AA/R6 dry cell batteries.
Insert the batteries from the - end, making
sure the + and - polarities are correct.
• Follow the warnings printed on the
batteries.
• Battery life is about six months to one
year, depending on how much you use the
remote control.
• The batteries we supply are only for
setting up and testing your TV, please
replace them as soon as you need to.
• If the remote control does not work
properly, replace the batteries.
Initial settings
When the TV is first turned on, it goes into
the initial setting mode, and you will see the
JVC logo. Follow the instructions on the
screen display to make the initial settings.
1 Press the Main power button on the
TV
The Power lamp lights red (for power on),
then green (for TV on) and the JVC logo
appears.
• If the power lamp stays red and does
not change to green:
Your TV is in the standby mode. To
turn the TV on, set the VCR/TV/DVD
switch on the remote control to the TV
position and press the # button. (See
page 12.)
EXT-1
EXT-
4
EXT-2
S
EXT-3
S
AUDIO OUT
L
Pr
Pb
R
L
Y
R
Yellow button
Blue button
7 button
s
Main power
button
Power lamp
HV-32P37SJE_Eng.book Page 6 Wednesday, September 3, 2003 8:05 PM