Filter
Top Products
24
Getting started
XV-501BK [J]
LET0145-001B
To use the remote control unit for CATV converter or
satellite tuner operation
You can operate the CATV converter or satellite tuner with the remote control
unit. To operate them, you have to change the remote control signal. Also refer
to the manual supplied with them.
Changing the remote control signal
1 Set
CATV
TV
DVD
on the remote control unit to CATV.
2 Press and hold
CATV/SAT
POWER
, then press
SET
.
Do not release
CATV/SAT
POWER
. Keep holding
CATV/SAT
POWER
until the next step is completed.
3 Holding
CATV/SAT
POWER
, enter the manufacturer’s code (two digits) using
0
to
9
.
See the lists on the right to find the manufacturer’s code.
4 Release
CATV/SAT
POWER
.
The following buttons can be used for operating the CATV converter or
satellite tuner (with
CATV
TV
DVD
set to CATV):
5 Try to operate he CATV converter or satellite tuner by pressing
CATV/SAT
POWER
.
If the CATV converter or satellite tuner turns on or off, you have entered the
correct code.
CATV/SAT
POWER
CH
+
–
0
to
9
Turns the CATV converter or satellite tuner on or off.
Changes the channels.
Selects the TV channels.
NOTE
¶
If there is more than one code listed for your brand of he CATV converter or
satellite tuner, try each one until the correct one is entered.
No. Manufacturer
01 GI JERROLD
02 GI JERROLD
03 GI JERROLD
04 GI JERROLD
05 GI JERROLD
06 GI JERROLD
07 GI JERROLD
08 GI JERROLD
09 SCIENTIFIC ATRANTA
10 SCIENTIFIC ATRANTA
11 ZENITH
12 ZENITH
13 PIONEER
14 PIONEER
15 HAMLIN/REGAL
16 HAMLIN/REGAL
17 HAMLIN/REGAL
18 HAMLIN/REGAL
19 OAK/SIGMA
20 OAK/SIGMA
21 OAK/SIGMA
22 TOCOM
23 TOCOM
24 RCA/PANASONIC
25 RCA/PANASONIC
26 RCA/PANASONIC
27 RCA(SAT)
28 SONY(SAT)
Manufacturer’s code list