Filter
Top Products
63
ENGLISH
Troubleshooting
What appears to be trouble is not always serious. Check the following points before calling a service center.
• For operations with the external components, refer also to the instructions supplied with the adapters used for the
connections (as well as the instructions suppl
ied with the external components).
• Messages (enclosed in “ ”) in the tables below are shown in the language selected on <Language>. (
31)
Messages described here are in the language of this manual.
Symptom Remedy/Cause
General
• No sound comes out of the speakers. • Adjust the volume to the optimum level.
• Check the cords and connections.
• DTS sound cannot be reproduced through any terminals
(Speaker out/REAR OUT/FRONT OUT).
• The screen is not cl
ear and legible. Sunshine from the windshield may cause this symptom.
Adjust <Bright> in <Picture Adjust>. (
31)
• “Position Error Push Open Key”
appears on the screen.
The monitor panel angle has been forcibly adjusted, or its
adjustment has been interrupted while opening or closing.
Press
, then [Open].
• “Mecha Error Push Reset” appears on
the screen, and the panel does not
move.
Reset the unit. (
3)
• “No Signal” appears. • Change the source.
• Start the playback on the external component connected to
VIDEO IN jack.
• Check the cords and connections.
• Signal input is too weak.
• “Protect” flashes. A speaker cord has shorted or it has come in to
contact with the
car chassis. Wire or insulate the speaker cord as appropriate,
then reset the unit (
3). See also the Installation/
Connection Manual.
• The buttons on the monitor panel do
not work.
When the monitor panel is open, only VOL +/– and
work. The other buttons do not function.
• The unit does not work at all.
Reset the unit. (
3)
Continued on the next page
EN_KW-AVX838[J]6.indb 63 10.1.18 5:43:05 PM