JVC LPT0543-001A VCR User Manual


 
12
Installing Satellite Controller
SITUATE SATELLITE
CONTROLLER
1
Place the Satellite Controller so that the path between
its transmitter and the satellite receivers remote sensor
is unobstructed.
ATTACH SATELLITE
CONTROLLER
2
Fix securely using the adhesive strip attached on the
back of the Satellite Controller.
MAKE CONNECTIONS
3
Be sure to connect the recorders AV2 (L-2) IN/DECODER
connector to the satellite receivers 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its
instruction manual.
CONNECT SATELLITE CON-
TROLLER TO RECORDER
4
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Satellite
Receiver
Control Setting
The following procedure is required if you receive satellite
channels through a satellite receiver. Approximately 20 seconds
before VIDEO Plus+ timer recording ( pg. 20) or Express timer
programming ( pg. 22) starts, the recorder sets its input mode
to "L-2" and automatically switches the satellite receivers
channels using the provided Satellite Controller.
Your recorder
Back of Recorder
Satellite receiver
Satellite Controller
Satellite receiver
Satellite Controller
(suggested locations)
Transmitter
AV2 (L-2) IN/DECODER
SATELLITE RECEIVER CONTROL
Setting satellite receiver's
brand and channel
After installation, set the satellite receivers brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
Turn on the TV and select the AV mode.
SAT CONTROL
21-pin SCART cable
(not provided)
TURN ON SATELLITE
RECEIVER
1
Turn on the satellite receivers power.
ACCESS MAIN MENU
SCREEN ON RECORDER
2
Press MENU.
ACCESS INITIAL SET
SCREEN
3
Press %fi to move the
highlight bar (pointer) to
INITIAL SET, then press
OK or
#
.
MAIN MENU
MODE SET
VHS MODE SET
DV MODE SET
AUTO CH SET
MANUAL CH SET
OUTPUT/INPUT SET
INITIAL SET
[
5
] =
[MENU] : EXIT