Filter
Top Products
20
123
456
789
1
2
1
2
3
0
3
4
4
ACCESS VIDEO PLUS+ SCREEN
2
Press PROG.
The front display panel looks like this:
ENTER PLUSCODE NUMBER
3
Press the NUMBER keys to
enter the PlusCode
number of the programme
you wish to record, then
press OK.
● If you make a mistake,
press and input the
correct number.
The PlusCode number you enter appears on the front
display panel:
The display panel shows only a 4-digit number.
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
4
The VIDEO Plus+ Program
screen appears (if you’re
just starting out, “P1”
appears).
The display panel shows the
programme start time.
Pressing changes the
display to the programme
stop time, then the date and
preset position.
IMPORTANT
Make sure the preset position number you wish to
record is displayed; if not, see "VIDEO Plus+
®
system Setup" on page 73 and set the Guide
Program number for that PlusCode number
correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press and input a valid PlusCode number.
● If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 21.
VIDEO Plus+
®
Timer
Programming
Before performing the VIDEO Plus+ Timer Programming:
● Make sure that the recorder's built-in clock is set
properly.
● Select the recording deck by pressing VHS or DV.
● Insert a VHS (or S-VHS) cassette with the safety tab in
place, or a Mini DV cassette with the erase protection
switch set to "REC".
● Turn on the TV and select the AV mode.
With the VIDEO Plus+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognise.
Perform step 1 in the left column.
BASIC OPERATIONS (cont.)
PROG
NUMBER
WEEKLY
DAILY
VIDEO PLUS+
[0 – 9] = VIDEO PLUS+
[
+/–
] : EXPRESS PROGRAMING
[PROG] : EXIT
SP
VIDEO PLUS+
12345678
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
VHS – P1 –
VIDEO PLUS+ 123456789
START STOP
21:00 = 22:00
SP VPS/PDC OFF
DATE TV PROG
25.12 1
BBC 1
: OK
PDC
SELECT DECK
1
Press VHS or DV.
ACCESS VIDEO PLUS+ DISPLAY
2
Press LCD PROG.
The LCD panel looks like this:
ENTER PLUSCODE NUMBER
3
Press the NUMBER keys to enter the PlusCode number of
a programme you wish to record, then press .
●
If you make a mistake, press and input the correct number.
The PlusCode number you enter appears on the LCD panel:
Then go to step 4 in the right column.
You can use the remote control with LCD panel to enter the
PlusCode number.
OK
SP/LP/EP
LCD PROG
LCD panel
STOP+/–
DV
VHS