Filter
Top Products
E
1.
In order to remove the two blind plates, remove the four
screws from the SCSI connector installation section at the
rear of the CD/DVD Library (drive storage cover).
2.
Insert the provided SCSI cable through the installation hole
from the inside of the drive storage cover and secure it with
the four screws.
Ⅵ Remove the connector cap of the SCSI cable for instal-
lation.
Ⅵ Be sure that the SCSI connector is inserted in the cor-
rect direction. (It should be the same as the direction of
the SCSI connector "SCSI-A.")
3.
If the cable or the terminator are not being connected to
the OUT side of the SCSI connector ("SCSI-D"), place the
connector cap over it.
1.
Insert the MC-R433U from the rear of the CD/DVD Library
Ⅵ Be sure not to damage the sensor slit.
Ⅵ Make sure that the direction of the MC-R433U is correct
when inserting it.
Ⅵ Be sure that the cables connected to the rear of the CD/
DVD Library are not caught or pinched when inserting
the MC-R433U.
2.
Insert the MC-R433U slowly until the screw installation hole
located on the side of the MC-R433U and the screw instal-
lation hole located on the drive locking section are aligned.
3.
Screw in the provided drive locking screw to the screw in-
stallation hole of the drive locking section.
Ⅵ Tighten the screw firmly.
Ⅵ If the drive locking screw is loose, the drive and/or Li-
brary may be damaged.
Sensor slit
MC-R433U
Drive locking
screw
MC-R433U
<MC-R433U insertion direction>
<MC-R433U locking method>
<Provided SCSI cable connection method>
* If the provided SCSI cable is not used, go to "Procedure for Con-
necting the Cables to the Back of the MC-R433U" on the next
page.
Blind plate
Connector cap
Drive storage cover
Provided SCSI cable
SCSI connector
mounting screw
Procedure for Installing the MC-R433U in
the CD/DVD Library
Procedure for Attaching the Provided
SCSI Cable
●
Connect the MC-R433U to the CD/DVD Library.
When necessary, two or more SCSI bus channels
may be used by adding the provided SCSI cable.
If the DVD-R is recorded intermittently due to an in-
sufficiency in the recording transfer rate on the SCSI
bus, the recording quality may deteriorate and play-
back malfunctions may occur.
Also refer to the instruction manual for the CD/
DVD Library.
CONNECTION
03.7.10, 2:12 PM4