JVC RM-C1400 Projection Television User Manual


 
78
Lamp Replacement
Lamp Warning
It is very important that you NEVER TOUCH THE NEW LAMP’S GLASS. Dirt or oil
from your ngers may cause the lamp to break.
Replace the lamp with part number PK-CL120U only! The television is designed
to work specifically with this lamp. Using a different lamp, or a third-party
manufacturer’s lamp could cause a malfunction and or damage to the television.
This television uses a 120-Watt high-pressure mercury lamp to project images onto the
television screen. When the lamp nears the end of its operating life, you may notice the picture
becoming dark. When the picture begins to darken, or the lamp burns out, it is time to replace
the lamp. The following instructions will tell you how to safely replace the lamp.
Under operating conditions, THE LAMP WILL GET EXTREMELY HOT AND WILL
CAUSE SEVERE BURNS IF TOUCHED.
Before attempting to replace the lamp, make sure the television has completely run
through its cooling cycle. Turn the power off and wait until the LAMP LED blinks very
slowly and turns off completely. Unplug the TV. If you feel any warmth as you place
your hand near the lamp, DO NOT TOUCH IT. Wait until the lamp has completely
cooled before attempting to replace it. After turning the power off, wait at least 1 hour
or more.
NEVER replace the lamp while the TV is plugged into the wall outlet. Touching the
metallic portion of the lamp may cause an electrical shock.
Do not keep the TV on for more than 24 hours consecutively. There is the possibility
of the life of the lamp being shortened.
The life of the lamp changes depending on the atmospheric temperature and altitude
in which the TV is being used.
Please read these instructions fully before attempting to replace the lamp. If you feel
unsure about replacing the lamp yourself, call a service technician.
Lamp Message
If this message appears when you turn the TV
on, you need to replace the lamp. See page 79
on how to replace the lamp.
Note:
• This message will appear every time you
turn on the TV when the lamp needs to be
replaced. Press the OK button to make the
message disappear, or replace the lamp.
LAMP NEEDS TO BE REPLACED.
REFER TO OWNER'S MANUAL FOR
REPLACEMENT INSTRUCTIONS.
AFTER REPLACING THE LAMP,
PLEASE RESET TIMER IN THE TV
MENU.
PRESS OK, IF YOU DO NOT WANT
TO SEE THIS MESSAGE AGAIN.
LCT2172-001C-A English.indd 78LCT2172-001C-A English.indd 78 3/26/07 8:59:33 AM3/26/07 8:59:33 AM