Filter
Top Products
16
English
Maintenance
Handling Discs
How to handle discs
When removing a disc from its case, press down
the center holder of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges. Do not
touch its recording surface.
When storing a disc into its case, gently insert
the disc around the center holder (with the
printed surface facing up).
• Make sure to store discs into the cases after
use.
To keep discs clean
A dirty disc may not play correctly. If a disc
does become dirty, wipe it with a soft cloth in a
straight line from center to edge.
To play new discs
New discs may have some rough spots around the inner and outer
edges. If such a disc is used, this unit may reject the disc.
To remove these rough spots, rub the edges with a pencil or
ballpoint pen, etc.
Moisture condensation
Moisture may condense on the lens inside the unit in the following
cases:
• After starting the heater.
• When the unit is moved from the extremely hot place to the
extremely cold place.
Should this occur, the unit may malfunction. In this case, eject the
disc and leave the unit turned on for a few hours until the moisture
evaporates.
CAUTIONS:
• Do not insert any disc of unusual shape — like a heart or flower;
otherwise, it will cause a malfunction.
• Do not expose discs to direct sunlight or any heat source or place
them in a place subject to high temperature and humidity. Do not
leave them in a car.
• Do not use any solvent (for example, conventional record cleaner,
spray, thinner, benzine, etc.) to clean discs.
EN15-18.XL-R910[C]_f 01.3.13, 5:40 PM16