Filter
Top Products
15
Figure: E
INSTALLATION AND CONNECTION
• Lift up the turntable and place it carefully on the mounting plate facing in the direction of travel
(see illustration Fig. E) (do not step on the plug connector and do not kink/crush the cables!).
The through holes on the turntable must be perfectly aligned with the threaded holes on the mounting
plate. When lowering, make sure that the cables are fed through the cable gland and are not crushed.
• Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening
screws into the thread. Tighten the screws to a torque of 6 Nm.
• To prevent water vapour from inside the vehicle reaching the turntable through the roof gland, thread
the two cables through the sealing gasket supplied (see Fig. E) and insert this into the roof gland until
it reaches the stop. Insert the plug into the third cable duct which is not used. Make sure that no tensile
loads are acting downwards on the sealing gasket as this can cause it to fall out over time.
Gasket with plug for
the unused duct
Battery, ignition
Receiver
Direction of travel