Filter
Top Products
21
INSTALLATION AND CONNECTION
• Lay the coaxial cable to the UFS 740sw.
• Lay the turntable power supply cable (3-pin plug) to the battery.
Avoid laying the cables across sharp edges and secure the cables against possible chafi ng
points.
• Connect the coaxial cable (coming from the turntable) to the “IF IN” F socket on the rear of the
UFS 740sw.
• Place the infrared sensor for the receiver close to or directly on top of the TV set and lay the
cable to the UFS 740sw. Connect the 6-pin Western connector at the rear to the socket marked
“IR REMOTE IN”.
Isolate the on-board power supply (master switch “off” or disconnect negative pole of on-board power supply
battery) before commencing the following work:
• Connect the power cable supplied (depending on the power supply available in your motor home or
caravan, either a 12 V supply or a 230 V supply via a power supply unit) to the “
” socket on
the receiver.
Make sure that the “inline” integrated fuse (5 A) of the cable is fully plugged in and is intact. If the fuse
blows, the source of the fault must fi rst be eliminated. The fuse must only ever be replaced by a fuse
with the same rating (5 A).
The fuses in the cable and in the receiver may never be bridged – cable fi re hazard!
• At the connecting point for the power cable, the voltage must not fall below 10.9 V even with a load
of 12 A. Otherwise optimum functioning can no longer be guaranteed.
• Connect the power cable to the respective socket in your motor home or caravan (12 V or 230 V).
Note: Lay the AV cinch enclosed with the CAP 600 to the Scart cable. Take great care to plug the
cables into the correct sockets! The cinch connector must be assigned to the UFS 740sw and
the Scart connector to the TV set.
Reversal is not possible - unit will not function!
LAYING CABLES AND CONNECTING THE TURNTABLE
CONNECTING TO THE UFS 740SW